Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys ,I am lab up a topology of Hub and Spoke (Phase 1) Dynamic Multiprotocol Virtual Private NetworkI have used full-forms because page was not allowing to post shortcut keywords I advertised all the underlay address in AREA 0 , all (underl...
Hello , i'm new here sorry for any mistakesI labed up a scenario where i set up two independent ISP's between Branch and Remote-Branchand after router advertisment from Branch to Remote-Branch i tried to manipulate Branch routes entering at Remote-B...
Solved , man i think IOS as some type of BUG ,now i mirrored the same setup but this time with IOU images ,it worked fine , previously every 80 seconds it use to go down ,Now its stable Output : Thanks
Thanks for the suggestion,but it did not work i am using IOS 7200 , i did a another lab with 1-----2-----3 ,Point-to_Point connectivity between 3 routers ,and then configured same Enhanced Interior Gateway protocol for Overlay (Tunnel) , and Open S...
Split horizon are enabled by default to prevent looping in Enhanced Interior Gateway Protocol... all you're spokes multicast traffic are mapped to HUB underla network , so for say example R1 sends hello to Hub ,Hub will accept that packet and will no...
Sorry for the late Reply both scenario are working now , it was a configuration error from my sideTopology : Goal: Manipulating Routes to use ISP-1 for 60.60.X.X and ISP-2 for 50.50.X.X on Remote-Branch to reach Branch siteScenario 1 : Tagging comm...
Ya it worked (I SET the community at Branch & manipulated on Remote site) , but my question is why I cannot do the same from ISP's , I did the exact same configuration I just shifted the ISP configuration to Branch and its working, Any Idea ? Thanks ...
