About dennis.lloyd

dennis.lloyd · 02-03-2016

Hello everyone, second attempt since my first post didn't seem to work. I have a strange problem I can't seem to get my head around.. I have a network with 3 locations connected with tunnels, and routing with EIGRP between the three. Everything w...

dennis.lloyd · 08-02-2006

Hello everyone, I'm faced with a configuration issue on an existing AS5300 server------[IOS (tm) 5300 Software (C5300-JS-M), Version 12.3(15)]24 Serial network interface(s)60 terminal line(s)4 Channelized T1/PRI port(s)30 DSP(s), 30 Voice resource(s)...

dennis.lloyd · 02-04-2016

no problem.. I got into the habit of clearing the arp cache and mac address-table when moving hosts. depending on the expiry of the tables, it may cause issues when moving hosts.

dennis.lloyd · 02-03-2016

so the host that changed it's IP address, that is an access port I assume? can you show the port config for the port your host is on? and: sh mac address-table dynamic vlan 120

dennis.lloyd · 02-03-2016

can you show the interface configuration of the port-channel members on both switches? Also: sh int port-chan xxx switchport sh int port-chan xxx trunk sh int port-chan xxx status

dennis.lloyd · 08-09-2006

Hi, yes that is correct. I have never been able to dial up at 56K to our server, and am not sure where to start looking for a solution

dennis.lloyd · 08-04-2006

Thanks for the info, however going backwards I am not able to configure the AS5300 as a dedicated Dial-up access server for ISP customers to dial-up to 56KPerhaps the modem software is out of date on my router?

Member Since	‎06-24-2005 07:43 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

Port forwarding over GRE tunnels

AS5300 with IDSN PRI for VoIP and 56K dialup

no problem.. I got into the

so the host that changed it's

can you show the interface

Re: AS5300 with IDSN PRI for VoIP and 56K dialup

Re: AS5300 with IDSN PRI for VoIP and 56K dialup