Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a MDS 9148 that I have been trying to configure, so I blew away the configuration and ran setup again. It looked normal, I could access it from putty but when I try to use DCNM-SAN to configure it I get "Permission Denied" on everything, new z...
I'm booting my Windows 2008 R2 from SAN and it works fine. The only way I have been able to have additional disk from the SAN is to include them in the Boot Policy with a second vHBA. That does not seem right. What is the proper way to present addit...
I am having problems with Boot from SAN with my QLogic 5200. TAC will not support this switch but the say it may work. I have B200 M2 blades and VIC M81KR and FI 6120 in End-Host mode.. Has anyone worked with any thing like this?
I keep having a problem with KVM Console failing to connect because the same blade has 2 IPs. In the Admin/Management IP Pool (ext-mgmt) you can see the association of the 2 IPs. How can you get rid of the association? In Equipment/Server Maintenance...
I open a case with VMware and they performed the following steps:Rebuild the VirtualCenter agent configuration file on the ESXi host:Caution: This step removes all host and virtual machine historical statistics counters. If the VMware ESX host is r...
It's working!!!Most everything you posted worked except for one thing. For some reason beteen UCS, Qlogic switches, and Hitachi 2100 SAN, I could not use LUN 0 for Boot. I had to use the LUN number that was defined in the Hitachi SAN.I have spent ho...
I get it. So here is what I have:UCS Boot Order where 50:06:0E:80:10:4B:5B:89 is one of the Hitachi SAN interfacesFrom the QLogic switch the active Zone Set is Orica_denver where the Zone usydoz77 has all the Hitachi interfaces and the WWPN of the St...
