Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have two WLC2504 controllers working in HA N + 1.There are several SSIDs and vlans on them.A few days ago, after changing the addresses of the management interfaces (and vlans) on both i've lost access to the WebGUI from my current vlan.Now I ca...
Hi.I have some problem making LACP work correctly.I want to connect 3850 (2 switches stack) with 2960X (3 switches stack) with 2 SFP-10G-ACTIVE-CABLE's.My configuration: 3850:* interface TenGigabitEthernet1/1/1description --TO-2960X--switchport mode ...
Ok it's getting funnier.I can't access my WLC's from VLAN99 via ethernet cable (192.168.99.5), but i can from VLAN99 (192.168.99.6) via WiFi...I guess that problem is caused by some rules on my FortiGate (gateway).However, there's no ACL on WLC.I'll ...
Cisco 2504 WLC don't support real full HA.They only can be configured as PRIMARY and SECONDARY, so there's no something such RMI.Both devices have their own mgmt addresses.Or did i miss something?
Can it be a routing issue if ping works well? Path is the same for all vlans:host -> gateway -> WLC I don't recall any ACL's on WLC...Whwrebto check it?
FYIIt was a switch issue.After replacing faulty unit, LACP went up correctly, no further configuration required.RMA rocks Thanks for help anyway. Regards.
