Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The webui interface use to show 5 to 6 tabs and I was able to do some configuration from the browser. Now the browser is only showing me monitoring tabs. Not sure why, any thoughts? The switch is version 16.6.9
I am fairly new at this, very new to cisco products. I'm what you would call a nub.So my question is, I have 3650-48pq-E switch and g1/0/48 set up as a trunk port. When I issue a [show interface g1/0/48 trunk] it shows; vlans allowed on trunk as none...
I tried it with 3 browsers and still the same results. It's almost like I just don't have a high enough privilege level to access the GUI configuration tabs with my log in. I am able to get into the command line and program from there with no issues....
Thank you so very much. Connecting up the cables and assigning vlans to the other ports worked. I can't believe it was something that simple, but that is how it usually is.
Ok I just pasted everything into the email and not through a attachment this time.I also Included the [SHOW INT G1/0/48 TRUNK] which is where I'm not seeing my vlans showing up.CiscoPPN#sh runBuilding configuration...Current configuration : 6287 byte...
Thanks for your response. You had caught me after I had left work for the day.As you asked I have attached the SHOW RUN and SHOW INTERFACES TRUNK outputs
