Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a Ipsec between my cisco router and a cisco asa managed by other team. By any chance is there a way to configure a monitoring between the peer device for udp port 500 or the traffic inside the tunnel. With out configuring anything/ip sla res...
We are having a DMVPN connectivity(Attached NW Diagram). Dynamic spoke-to-spoke communication between 2 and 3 is having an issue but the underlay NBMA IP is having recahability and also other connectivity is working fine and as expected between spoke...
If i have 2 static route 10.0.0.0/8 and 10.105.0.38/32 in my routing table. And in bgp If I adverstise network 10.105.0.38 255.255.255.255.What will happen if static route 10.105.0.38/32 is unreachable or down, will bgp still adverstise the network ?...
Hi Everyone,Need help in this issue, bgp is still advertising the route even though the next hop for the static route is down.Scenerio.(I've attached a rough NW diagram.)Their is a client managed Nexus switch connected to Router R2, they did some act...
Topology is attached.I was into one activity where everything was working fine. But however after shutting down the link between Nexus Primary switch and 3650 Switch1 connected to Primary Nexus, I was not able to ping the next hop Ip of firewall from...
Thankyou, So Could this be an issue ? and will you please let me know how can i make this neighbor full establish.Also traceroute to Tunnel IP or the multicast IP ? I checked trace for tunnel IP it is not going on 1st hop for any of the spoke but i c...
Spoke 3 Output:chcrt7301gdn#sh ip ospf neighborNeighbor ID Pri State Dead Time Address Interface10.51.234.228 100 FULL/DR 978 msec 10.51.232.99 Tunnel104410.51.234.227 100 FULL/DR 870 msec 10.51.232.67 Tunnel103410.49.23.4 100 FULL/DR 920 msec 10.51....
Spoke 1 Ouptut:lonrt8001ccci#sh ip osp neNeighbor ID Pri State Dead Time Address Interface10.134.131.110 0 FULL/ - 00:00:39 10.51.145.70 GigabitEthernet0/0/3.215210.134.130.115 100 FULL/DR 918 msec 10.134.131.115 Tunnel80110.134.131.119 45 FULL/BDR 9...
HI @balaji.bandi ,Yes there is HUB to HUB connectivity.Spoke 1 and 2 is working.chcrt8001ccci#pi vr CCCI 10.134.131.109Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.134.131.109, timeout is 2 seconds:.!!!!1 192.168.2.109 10.134.13...
