Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloGood day to you. Could you please help my DMVPN question.R1 is hub, R3, R4, R5 is spoke. my lab is run in PNET, Configuration had attached.Q1. ip nhrp redirect should input at hub or all spoke?Q2. before I input "ip nhrp redirect" and "ip nhrp s...
HelloGood day to you.Could you please help my DMVPN question.R1 is hub, R3, R4, R5 is spoke. my lab is run in PNET, Configuration had attached.Q1. ip nhrp redirect should input at hub or all spoke?Q2. before I input "ip nhrp redirect" and "ip nhrp s...
Hello I am learning CCIE Routing and switch content. it need IPSEC but not describe detail on the CCIE routing and switch book.May I have your advise which book is good to understand IPSEC?Also I am interesting on Meraki SD-WAN. Could you please advi...
HelloThanks for your time to help.I am learning EIGRP. May I have your help?In Reliable Transport protocol (RTP), after device send packet to 224.0.0.10, it will wait a time call multicast flow timer. This default is 50, unit is second.If not receive...
HelloI am learning on lab. Would you please help my below 2 question.Q1. Why I don't get L1L2 connection type between R3 and R4?Q2. Should I suppose no down because of I have 2 area address connection after I remove one of it?Thanks for your time. R3...
Dear MHM Thanks for your help to spend so much time to have lab. You lab still not show any summary route and not limit individual route of spoke.I trying to achieve benefit 1, but end of benefit 3 said not possible to have summary by OSPF. I think I...
Hello IrakliFirst, this output is normal and no problem at your configuration.R2, R3, R4 and R5 around the switch will work in same subnet for OSPF. R5 as DR and R4 as BDR, R2 and R3 send LSA to R5, R5 group LSA update to all members in this subnet ...
Hello MHMThanks for your time.I have new finding would like to share.Below is static route test without override.below is override test. From it, I know % sign is correct and normal result. Below is OSPF test.From guide "IP Address - NHRP configurati...
Hello M02@rt37Thanks for your reply. After more lab, I have more understanding. Could you please correct me if I am wrong.1. For Q3, spoke can not communicate with each other. Because of in phase 1, spoke use "tunnel destination " rather than " tunn...
