Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,Can someone please tell me how to unassign IP from interface using FTD cli. I made a mistake and I assigned an IP to the Management interface and now I can get to the gui for my FRP1010.I need please the cli to take off the IP and put back to ...
Hi,I need help please. I'm looking to create a port forwarding on my firewall. I am trying to come from the outside through UDP port to the inside to my network.Can someone guide me please how to create the Nat rule. Thanks Ammar
Hi, Trying to set up a VPN connation to my home firewall FPR 1010. The plan is to have access from my phone or any computer to my home networks, so I have few questions: 1- Do I need a license? if not that will lead to question 2 2- There is a script...
Hi,I have ASA 5506-X every time I reboot the firewall or power goes out I have to re-upload the image through TFTP. It wont save the configuration. After reloading the configuration and trying to WR I get below: please help!! ciscoasa(config)# wrBuil...
Rob. again you are the Man!!!Thank you VERY much. I am learning a lot from you! I wish Cisco had some service contract for personal not only for business . Maybe one day!Thank you, Ammar
Hi Rob,Thank you very much for the replay. but the issue is I don't have a service contract. I have this Firewall for home. I don't have business.I need to download the VDB package.There is anyway I can download the package?Thank you,Ammar
Hi guys,I need your help please or tell me please how to fix it.I had to reset my FRP 1010 to factory settings. I had a backup and I deployed but i don't have connectivity and everything seem fine. but I am getting this message below A package file r...
