Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to have three PC inputs on the SX80 without the need of a Crestron controller/programming?
If not, is there a video switcher you can control with the SX80 and the Cisco Touch 10?
My goal is to have three video inputs without the nee...
Can someone help me understand the new feature in Jabber Guest 10.6? The release note for 10.6 says BFCP is now supported, which is to receive screen sharing, but I always had this feature available. For instance, I can dial to a multipoint or point ...
When running the TMSXE configuration wizard I am unable to connect to TMS by using its VIP FQDN. If I use each tms server name individually it works, but not when using the cluster name or VIP address (behind F5 NLB)I can connect to TMS website using...
I did go over the In-Room Control Guide and was kind of confused. Which Crestron Processor model did you used? I read a discussion here that said the modules to control Crestron were not available yet.
By the way, thanks for all the information! ver...
I can invest in a control processor, but doing some reading, I am not sure how to make the Touch 10 control it using the in-room control feature.
have you done this?
I will have to test. My challenge is, with auto sensing the user does not have control over which workstation to use, unless they manually change the input on the video switcher. This adds complexity to the setup since they will be using the Touch 1...
Patrick,
How does the video switcher works? I can't use two HDMIs since my deployments have SpeakerTrack60.
Do you have control of your inputs on the external video switcher?
