Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have several ASA appliances on our production network. We are moving away from Aruba Clearpass and moving to Cisco ISE. This will include our TACACS functionality.I see in the ASA configuration in ASDM where i configure the AAA server groups. I ...
Community,I have one of my IT peers whom is in the process of implementing Rubrik boxes for Cloud backup at both our Headquarters and at our DR site.Each box will live in the Servers vlan in each respective site.We route between those two sites via a...
I am needing to open up a port that will go from outside to inside for TACACS authentication. I have created what i beleive is the necessary NAT translation from an available public IP address that our provider has given us in a publicly routable bl...
We have Cisco Secure client image files loaded on our FMC platform. I beleive these are loaded in order that a connecting VPN client that has an older version of Anyconnect can receive a newer version from FMC when the connection attempt is made. We ...
Community,We have a Juniper Core switch model qfx5100-48s-6q in our environment. All of our other switches are Cisco. We are currently rolling out ISE to use for TACACS+ authentication. Currently the Juniper is configured in Aruba Clearpass which ...
HI MHM,The documentation that i have read has indicated i should use packet tracer from the FMC interface, and i have done that. I must admit it is a bit confusing, as I am not exactly sure what values to use, such as for Source Type value.. and to ...
I do not know how to run packet-tracer from the CLI, only from FMC. Most of what i have read has indicated that Packet-Tracer must be run from the FMC in this environment. Is that not correct? Thank you.
We ended up performing a "factory-reset" from rommon mode. then we were able to boot from a usbA: location where we had the file "cisco-asa-fp1k.9.23.1.SPA" stored. Another interesting point was that in the putty CLI i had established thru a serial...
Rob,Interestingly enough, it does NOT complete.. I can tell this by looking at the TFTP server.. there is a message indicating that the file starts transferring, but then there is another message indicating "Interrupted by client, received error pack...
