Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to run pyATS on a few CSRv routers and retrieve their routing tables. When I execute learn, pyATS looks for a vrf identified as 'default' as noted in the console file. I do not have a vrf labeled 'default', it's just the global routing ta...
I am looking to deploy a ISE Guest Portal for my guest network users. In the deployment design, I am also looking to separate the guest traffic through a guest vrf. In doing so, if a guest attempts to join the network through a SSID that is vrf off, ...
I'm looking to upgrade to vSphere 6.7. I want to check to see if CUCM 12.0(x) is compatible with the updated version of vSphere. Looking at the matrix compatibility link below, it does not show support for this combination. However, CUCM 11.5 and 12....
I have received the results of a PCI Pen Test that was ran against the network, and I am seeing a flag for the CVE-2018-0101 vulnerability for the ASAs. I am currently running ASA version 9.12(4)13/ASDM 7.13. I thought that this was resolved by Cisco...
I currently have two Firepower 2110 devices that I want to use for an HA pair. However, I have one Public IP for the outside interface. Is there a way that I can still set these devices up as an HA pair, similar to the ASA, if I run them through a sw...
Found the issue. It turns out that the 'Endpoint Attribute Filter' was checked under Administration-> System->Settings-> Profiling. Once I unchecked it and cleared the auth sessions on the switch I was unable to retrieve all of the in NMAP informatio...
All listed were checked and verified. I am seeing UDP-port 161 coming across, but I am not specifically seeing SSH-port 22 even though it's a console device. Prior to the 2.7 upgrade this was coming across. Paul
