About paul.a.facey

paul.a.facey · 12-27-2016

Greeting, I have configure NAT on my Cisco 2651XM series router OS 12.2(8r). When I check the NAT table it only shows that UDP traffic is being routed nothing else. Any Ideas ? Building configuration... Current configuration : 1160 bytes!version 12...

paul.a.facey · 12-30-2016

I appreciate the help. I just want to make sure that I understand what the problem was, since I am jumping to another router it was necessary to define the route to the next router which I had not done. If I have this wrong please feel free to let m...

paul.a.facey · 12-29-2016

so..it should not be it should be full duplex which I will correct. I am starting to believe the problem is the router itself, every time the router is power cycled it comes back to the initial configuration mode as if it has never been setup before...

Member Since	‎12-27-2016 08:56 PM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	3

User Statistics

User Activity

Cisco 2651XM NAT issue

I appreciate the help.

so..it should not be it