About iPhoneFreak

iPhoneFreak · 06-06-2020

I do have a routing loop between routers R1 and R2. Does anyone of you have any suggestion for me on how to solve the problem? I did attach my project in Packet Tracer!

iPhoneFreak · 06-06-2020

In the attechments you find my whole Network in PacketTracer. Can somebody tell me, if my NAT is working correctly?It should be very simple, as it is simply about 5 lines of code. The dynamic NAT is working on the R7-Router. Here the running-config o...

iPhoneFreak · 06-06-2020

If I use the simple PDU option in PT and firstly click on the PC1 and then on the PC11 for instance, then the routing loop occurs.

iPhoneFreak · 06-06-2020

Even if I enter the command on both Routers, there still is no change and the packets go on between R1 and R2 forever.

iPhoneFreak · 06-06-2020

That did not really help me. I entered the no command for both the redistribute rip subnets and the redistribute ospf 1 metric 12 commands only on Router R1 and there still is the routing loop. Any suggestions?

iPhoneFreak · 06-06-2020

Thx, that was it!

iPhoneFreak · 06-06-2020

My question is the one below - I repeat it here:Ok,I have one last question: At the moment I am not able to ping from one IPv6-PC to another IPv6-PC. The packet dies in simulation mode instantly at the PC and does not go further. Does anyone have any...

Member Since	‎06-06-2020 01:56 AM
Date Last Visited	‎06-26-2020 12:54 PM
Posts	14

User Statistics

User Activity

Routing Loop in my Project - RIP + OSPF

Can somebody tell me if something with my NAT isn't working correctly?!

Re: Routing Loop in my Project - RIP + OSPF

Re: Routing Loop in my Project - RIP + OSPF

Re: Routing Loop in my Project - RIP + OSPF

Re: Can somebody tell me if something with my NAT isn't working correctly?!

Re: Can somebody tell me if something with my NAT isn't working correctly?!