Hello again Saji.
If you are expecting (and allowing) people to connect a switch on the GBIC's then I would not suggest enabling BPDU guard since it will send the port into an err-disable state. Assuming auto-recovery is not enabled, you would need t...
Hello Allison.
The misleading thing about this error is that it is not an error but a simple warning, which is why you are able to proceed to the login screen. I am not familiar enough with the firmware version as to pinpoint the problem but my best ...
Hello Saji.
It is possible to have loop guard and bpdu guard enabled on the switch at the same time on the root; however, I would not reccomend enabling bpdu guard on the root switch since bpdu guard is usually enabled on edge ports (port where a sin...