Hello Cisco, I'm trying to configure in-band management on the ACI fabric, but the APIC in-band management IP address is not being advertised into the in-band management VRF routing table. The Leafs can ping each other in the in-band management VRF b...
Hello Cisco Community,Can I connect a 40Gig firewall interface to my 9372TX QSFP ports even though the port usage says "fabric, fabric external" ?Can some one explain what usage "fabric, fabric external" means, because I suspect I can connect a 40Gig...
Hello Cisco Community, I'm getting the error you don't have permissions to capture on this device from the cisco APIC. Would you please provide recommendations in order to capture APIC traffic over it's management interface. apic# tcpdump -i oobmgmt...
Hello Cisco community, I have a situation where I've used the APIC quick start wizard to configure the NTP server for the ACI Fabric(Leaf/Spines) and I'm getting the error "NTP Server not selected for sync".The default out-of-band EPG has been config...
Hello, can someone help me configure a whitelist on Firepower to only allow access to netflix. There's a built-in application filter for netflix's but I get an error.
Hey, the attached Cisco document help understand the configuration. The specific configuration is below. Make sure you use the destination keyword when creating your service object group instead of source. object service REAL_SRC_SVCservice tcp ...
Hello RedNectar, thanks for the detailed reply!To answer your question: I want the APIC to be able to ping all the Leafs because in traditional networking you should be able to ping the default gateway and any host on the local subnet without any spe...
Hey Thank you for the help but the issue is still that the APIC is not able to ping the Leaf switches but all the Leaf switches are able to communicate with one another over the inband managment VRF.
Yes I read your previous post and your blog and followed the exact same steps. I even created a new vlan pool and applied the access policy to the APIC interface but still no success. Is there a way to see the allowed vlans being trunked across the ...
Quick question because I don't want to create an OUTAGE losing configuration connectivity to my Leaf switches. If I add access policy to the ports connected to my leaf switches, I will not lose configuration connectivity to the leaf switches?
