Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In a Cisco ACI fabric, leaf and spine switches are crucial components that enable high-performance, scalable, and resilient data center networks. Over time, you might need to replace hardware due to failure, upgrades, or scaling needs. This document ...
traffic storms can be generated from any device due to manufacturing or loop, which is hard to figure sometimes. however we can mitigate that by implementing the appropriate features.
it is recommended that we enable storm-control on outer facing ACI...
Initial Cisco APIC Setup
When the Cisco Application Policy Infrastructure Controller (Cisco APIC) is launched for the first time, the Cisco APIC console presents a series of initial setup options. Beginning with Cisco APIC release 6.0(2), the initial...
as far as I know, this option will only be available during the initial set up of the first APIC, as different fabric ID means different site, where multi-site NDO is used.in Multipod, fabric ID must match, POD ID is different
Hi @a12288 migration to different HW, should be similar process, however C93600CD-GX could be registered as Spine/Leaf.
https://www.cisco.com/c/en/us/products/collateral/switches/nexus-9000-series-switches/nexus-9300-gx-series-switches-ds.html
in s...
Hi, very good question, actually as per my understanding, to distinguish the traffic ACI use the extra-vxlan header,
if I get your question right, to make forwarding across the fabric possible, ACI tag the identifier that is shared among all the node...
Ans- Once the parent leaf switch comes back online with the new software version, it will automatically push the new firmware to the connected FEX units.
