Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, all,I'm wondering what would be the best practice for deploying MS150 switches within an environment that already has MS350 switches. I understand the MS150 switches cannot be stacked with the MS350 switches. Just trying to come up with a plan. A...
Hi, all,We've configured all of our ports of our core switch (MS425-32) to be mirrored to a destination port on the same switch. The destination port has a device connected to it that is being used to capture the traffic from the source ports.The iss...
Hi Meraki Community,The issue I need help to resolve is getting phone paging to work across multiple floors that each have their own networks for their phones.I have three floors with their own networks.I want to be able to send a page from a phone t...
Hi all,I recently received a Cisco 891F-K9 router and an MS130-8X switch. I'd like to set them up to use for a home lab to start learning. I have Verizon as my ISP. How would I set these up? I'm assuming the Cisco 891F-K9 router will plug into one of...
Hi all,I was recently given a Cisco 891F-K9 router and I'd like to use it to setup a home lab. I'm fairly new to networking so I'm not going for anything complicated, just basic Internet access and I'm assuming the GE LAN ports 0 - 7 can be used to c...
Also, found out that the minimum firmware version for the MS150 is 17.1.4. I was told that the Dashboard will give you an error if your network isn't on 17.1.4 firmware. Thought I'd share the information in case anyone is interested. Thanks for all t...
Hi @DarrenOC The model we purchased is the MS150-24MP-4X, which I think has 4 10Gbe SFP+ ports that I can use to connect to the MS350 models. Yes, your assumption is correct in thinking that these MS150 switches will go in the same rack as the MS350 ...
