Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears I have allowed to access a websever on HTTPS port onlythe problem is when a client tries to access HTTPS , firepower will allow client to access webserver and in event viewer will show ClientIP:sourceport to WebServer:443 allowed but the prob...
Hello I want to implement Duo integration with your Cisco Firepower Threat Defense (FTD) SSL VPN to add two-factor authentication to AnyConnect VPN logins.without using ISEThis Link ( https://duo.com/docs/cisco-firepower ) describs steps on how to d...
Hello is there any way to change Bandwith or traffic units in Kbps to Mbps in cisco firepowerbecause all widgets in the dashboard dispalys data in Kb not in Mb
Dears I have firepower and I configured site to site vpn between ,protected network in site A is 10.2.3.4 and in side B is 172.15.3.4, I added tow Access rule policyes to reah each other,when I ping from Site A to Site B,I can see in Analysis-Events ...
Hello I have a VPN connection with Site B and C, I have ping between my local Subnet to Local Subnet of Both sites B and C my question is how to allow local subnet of B to reach C? is this possible by just allowing in Access Policy Rule? I have attac...
Hello Balaji The webserver is located in DMZ in our Network(a Public IP is NATTed to the Webserver IP), when some one tries to reach it from Outside (Public) this issue will occur
Can you please share authproxy config file please, Or did you take any other steps rather than what is mentioned in the documentation. When adding RADIUS aerver in ftd, which one did yoi choos, base on routed or specific interface?
Thanks Rob for reply, did you configured duo with FTD? I have a concern that it can not be done without ISE. As I mentioned, I did exactly what is done in the documentation, and I checked the authproxy file authproxy_connectivity_tool.exe, all serv...
Hello Rob, No, Site B and C don't have a direct VPN connection, I want to route between them via My site and For your information I use Firepower to do the route between Site C and B
