Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have have an MX95 with few services behind.To publish these services we create a NAT 1:1 and allow inbound rules.Then on the top of that we also have an outbound rule that allow any protocols from any ip to any.My issue is : The published servi...
Hi,I have an ASA 5520 on FW 9.0(4).I have on it 3 subnets : inside (10.1.1.0/24)outside (1.1.1.2/28, webserver Public ip 1.1.1.3)DMZ (20.1.1.0, webserver DMZ ip 20.1.1.10)Clients on the inside are able to access internet without any issueWebserver lo...
Hi, I have all my 3750-x in 15.2 but one which is in 12.2.All are under ipservices licence. Can I upgrade safely from 12.2 to 15.2 without loosing the Ipservices licence? Many thanks by advance for your answer.
Hi, I have have an ASA 5520 wokring in multiple context for years now.Till now the first context was using the interfaces 0/0 and 0/1 and the second context the interfaces 0/2 and 0/3 But recently I had to add another lan to this configuration but, b...
Hi,
I just got a 5520 in 9.0.4, before I was using 8.2.1 on these machines.
So I noted some changes between these 2 releases.
Regarding the static PAT I'm a little bit blocked.
In 8.2.1 was easily able to publish serveral services for the same ho...
The screen I sent is related to publish service and regarding what's on top of my Meraki config page there is no other way to add inbound rules : My forwarding rules :
