Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all!I am trying to connect to a 4400n router via VPN on a Windows 7 PC. It connects and creates the tunnel, but I am getting the below error:The remote gateway is not responding. Do you want to wait?I have verified on the Cisco 4400 that my connec...
Hi all,I have a sorta silly question here. I just got a 3750 and all of the ports say they're part of FastEthernet3. So to check port 48, I would type:sh int fa3/0/48I was expecting to have it be FastEthernet0.I figure this is because of the Stacking...
Hi all!I am changing my companies network and I am stuck. I've dug through a number of articles and posts both up here and elsewhere and I am not sure what the problem is. In particular I've been through THIS article a number of times, worried that I...
Hi all,I am looking for someone's input on which is better. I am adding another ISP (and plan to use BGP). I am looking at having two 2811's with one connected to each ISP, or a single 2811 (with an additional HWIC) connected to both ISPs. I am not s...
Hi All.I have a Cisco ASA 5510 running Version 8.3(2) on which I've been having a problem getting a DMZ server to commiunicate back into the Internal network. While trying different ACL's and NAT's to get this to work I've come across something stran...
OK, finally got a chance to work on this when folks were able to let me in. I am on the latest firmware. I just spent the last few hours trying to get this to work and no dice.These routers are nothing but problematic. At another company they needed ...
Yeah, I've been remote all day. I was able to breifly check the status by connecting to someone's PC at the office and checking the router (that is how I verified the tunnel was created and up).Yes, pinging the WAN IP is disabled.Yes, I've tried both...
iarroyo,"Is your WAN getting a public ip address?"On the 4400, yes. I am able to connect to it from a remote office and it creates the tunnel.answers to the following:1. I've tried it with this on and off, error has not changed.2. I already did this,...
Hi iarroyo. Thanks for the quick response.Yes, I had enabled those 2 FW rules for ICMP and there is no 3rd party FW.Any other things I should check?Thanks!
Hi Carl.I was searching for something and came across this, since it wasn't answered I figured I give it a go. This comes with the caveat that there are tons of people way more qualified to answer this than me. I also realize it's been months since t...
