Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good evening, everyone! I have a stack of 3 Cisco C9300-48P-A switches which has been seeing a strange problem since early this morning. Every so often, switch #3 is the stack will simply reboot itself. These are the log message we are seeing: %FM...
I am trying to add a couple of WS-C3750X-48P switches located in a DMZ to Cisco Prime 2.1 and it is failed with SNMP Connectivity Failed and the Collection Status Details say SNMP Failure: No Response for SNMP Get request.The difference between these...
I have a stack of 4 Cisco WS-C2960S-48FPS-L switches running c2960s-universalk9-mz.122-58.SE1 code. One of our network monitoring tools is indicating discards on a certain port on the switch. Upon further investigation I am seeing the Total output ...
I guess the big red check by my other thread is keeping folks from replying, so I'll try another one. I was having problems with the Cisco VPN Client last week after installing/uninstalling ZoneAlarm. Over the weekend after sitting down and cleani...
I get the following error message after I type in the password and try to connect to one of our remote sites:The client did not match the firewall policy configured on the central site VPN device. Cisco Systems Integrated Client Firewall should be e...
I'll have to check to see if we have any standard outlets in that closet, it's pretty small and dedicated to just our network equipment. Yesterday we did migrate the few connections that were on switch #3 onto other open ports on the other 2 switches...
