Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Gurus, I am trying to establish a vpn between Meraki and non-meraki devices however I am having issues. I tried with Meraki MX68W and Forcepoint and that did not work. Then I tried with Meraki MX68W and Sonicwall and this didn't work either. Tried...
Hi Gurus, I am trying to establish a vpn between Meraki and non-meraki devices however I am having issues. I tried with Meraki MX68W and Forcepoint and that did not work. Then I tried with Meraki MX68W and Sonicwall and this didn't work either. Tried...
Hi Alemabrahao, Any idea how to open a support case with Meraki ? I have dealt with Cisco in past raising TAC case however I don't have cisco account with my current company to raise TAC case with them directly. Do I need to have an account or can I ...
Made changes to following: Pre-shared key is greater than 14 Still no joy As per Alex comment : Configure the peering on Dashboard so that the LocalID of the MX is whatever public IP its traffic is getting NAT'd toAny chance of explaining how to achi...
So, as per this document, I have configured on both side: https://documentation.meraki.com/MX/Site-to-site_VPN/MX_to_Sonicwall_Site-to-Site_VPN_SetupThese are the config on Meraki Side: Kindly let me know if I am missing anywhere any config ? Regards
Hi Both, Thanks again for your quick support. @alessandrodematos, as per your comment, seems I will have to add peer IKE ID ( private IP address of Meraki ) on Sonicwall Also, remote ID on Meraki ( public IP of sonicwall ). @ahoulton, for point A: I ...
Hi Alex and Alemabrahao, I am back with the same question. So VPN for Meraki which had public IP configured on its WAN interface is working fine. However another Meraki at different location which is behind NAT, I am required to configure VPN . Is th...
