Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,We have a UCS blade and one NetApp storage and that storage has been connected with FC.We want to connect a new NetApp storage to the existing UCS blade. For that, we have to FC port available in UCS Fabricinterconnect(Cisco UCS 6248UP).I ha...
Hi aLL I have 2 node HX-E-220M5SX Edge and I am trying to install Hyperflex. I am getting below error for entering third node IP address details. Please advice how can install hyperflex with two-node WITH hYPERFLEX INSTALLER(OVA) I have chosen the ed...
Hi All,i am going to deploy Hyperflex with Vmware for Testing Purposes.Are there CLI commands to do a factory reset of a new Hyperflex system and rebuild hyper flex again?is there any procedure for rebuild Hyperflex?
Dear Krik, The upstream switch is MDS 9148S 16 G Multilayer Fabric Switch and Fabric interconnect is Cisco UCS 6248UP.is it possible to connect Netapp to Fabric interconnect UCS 6248UP?
Dear Kirk, Thank you for reply If I am planning on using the same vsan and existing vHBAs on existing servers/service profiles, tWhat is change required on zoning( connection profile)? i want to connect both netapp storage to the existing server?do y...
Hi ,thank you for reply, If i register hyperflex node my intersight id and if i want to move hyper flex to another intersight id.is it possible to move to another id?
