About TimPickard

TimPickard · 07-20-2020

I am trying to use port 25 for an up-link to a home wireless router. It isn't a priority as I can up-link through one of the regular ports, but it is an annoyance. No matter what I change in the config of the switch it remains UP/DOWN. The link LED i...

TimPickard · 07-18-2020

I recently purchased a SG200-26 to replace 3 8 port unmanaged switches in my home network. When I connected it up everything seemed to work fine until I tried to install a new Sansco security DVR (wired cameras not IP). I believe the Roku had the pro...

TimPickard · 07-20-2020

I found the basic cause and therefore solution to this problem while troubleshooting with a friend. The thought crossed my mind that the Roku 3 might not have Gigabit Ethernet, so I checked. It does not. When I went to manual speed 100M and full dupl...

TimPickard · 07-19-2020

I reset the switch to factory and it had no effect on allowing the Roku3 to connect. I tried enabling Flow control and setting master on the port, also no effect. I changed it all back before returning the Roku to the router. Also no settings on the ...

Member Since	‎07-18-2020 08:32 PM
Date Last Visited	‎01-04-2022 06:10 AM
Posts	4

User Statistics

User Activity

ComboC ports 25 and 26 on SG200-26 won't pass information

Roku3 and Sansco security DVR can't connect through SG200-26

Re: Roku3 and Sansco security DVR can't connect through SG200-26

Re: Roku3 and Sansco security DVR can't connect through SG200-26