Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am trying to setup a WLAN for the first time but the WAP does not show up in the WLC. This is error I am getting from the WAP. I can ping the WLC from the WAP and vice versa. *Oct 10 14:54:52.085: %LWAPP-3-CLIENTERRORLOG: Peer certificate veri...
Hey I can ping the IP of the WLC which is 192.168.1.2 . When I try to access the page below just repeatedly asks for the password and username and does nothing. I have factory reset the WLC and rebooted it still same thing every time. This is the fi...
Hi, I have internet access with my router. FE 0/1 is WAN port setup for PPPOEFE 0/0 is standard port. Network setup - VDSL modem -- router 1 (1841) switch(2960) -- PC.Router 2 which can also ping the main router 192.168.1.1Summary Router 2 and PC do ...
Controller 2100 series. Image version 6.0.196.0. AP model AIR-LAP1142N-E-K9. This is the only AP I have. Show version ---Cisco IOS Software, C1140 Software (C1140-K9W8-M), Version 12.4(23c)JA2, RELEASE SOFTWARE (fc3)Technical Support: http://www.cisc...
Thanks the video i have been following cbt nuggets but all i was missing was the http:// at the beginning of the 192.168.1.2. It was as simple as that!
When i use the command show ip nat translation this shows nothing on router 1 and router 2. Router 1s updated file is below. also when i do a traceroute on router 2 it goes to the DG of 192.168.1.1 then just ends it cant get off the DGW .1S* 0.0.0.0/...
