Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,The scenario is that we currently have a project for 3 offices, all offices are being assigned by our local ISP with a Dynamic IP address. We wanted to utilize Meraki MX67C for the main office and Z3c for both local branches (devices were...
May I know which ports should I allow for my access list to allow my group policy objects to pass through my core switch which is a layer 3 switch. Here's a sample of the ports I used permit udp any eq bootpc any eq bootpspermit icmp 10.10.20.0 0.0.0...
Hi all, I can't seem to find a way to allow my GPO to pass through my core router(which has ACL running). I was able to determine that the cause of this was the packets were being blocked by the ACL because if I remove the ACL on the VLAN, the GPO ta...
Hi all, I can't seem to find a way to allow my GPO to pass through my core router(which has ACL running). I was able to determine that the cause of this was the packets were being blocked by the ACL because if I remove the ACL on the VLAN, the GPO ta...
I am having a problem pinging the outside interface from my inside network. I have already performed the static routing from which all routes will be able to access the internet, from ASAv I am able to ping the outside network but from my inside netw...
I have already allowed all of the ports possible, i have an implicit deny to all networks as i am limiting the access of this network to other networks especially to my server network, that's why i am only trying to figure out which ports should i op...
Thanks for the reply, I tried this one out but unfortunately, I am still not able to ping to the outside networkCoreSwitch#ping 10.10.10.10Type escape sequence to abort.Sending 5, 100-byte ICMP Echos to 10.10.10.10, timeout is 2 seconds:.....Success ...