Hello,When I try to apply an ACL to a Layer2 port, I am having this message. Does anyone know how to do it on nxos? SPOR-MPLS(config-if)# show run interface ethernet 1/7interface Ethernet1/7switchport mode trunkswitchport trunk allowed vlan 818SPOR-M...

Hello, I am having this error one one of our switches while the other looks OK. Does anyone have an idea? BB-1# show logging ip access-list statusERROR: Failed to build CLI response BB-2# show logging ip access-list statusMax flow = 8000Alert interva...

Hello,When I try to apply an IP ACL as a Port ACL, I am having that error message below. BB-1(config-if)# ip port access-group test inERROR: TCAM region is not configured. Please configure TCAM region and retry the command My TCAM configuration looke...