Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have done OSPF lab. In that I have noticed OSPF Designated ID in every Ethernet link is confusing about selection.
The selection Process is based on Priority or Router ID.
"OSPF deems a router more preferable if the priority for the interfa...
Hi,Below is my task to do. I have configured as per below network topology. Unicast routing is working from receiver to source and vice versa. But multicast routing is not working. I need to know the reasons for this and also the task question also.P...
Hi,I have learned how to create subinterfaces on a router for inter-VLAN routing purposes. Recently, I have noticed that routers can be connected to other routers using subinterfaces. Can somebody explain how to do that? Please find below the network...
Hi all,I have attached network topology for the Multicast routing. In this task, we have to subscribe Server 1 & 2 to Multicast A and Multicast B groups feeds.But Both server 1 and 2 are only receiving Multicast B feed only. I want to know why both s...
Hi all,I have configured BGP on R1,R2 & R3.R1 & R2 : IBGP : (ASN: 65100)R3 - ASN: 64519R3 received 192.169.1.0/24 prefix from R1 & R2. R3 chosen route from R2 as best path.Based on which attribute R3 selected the best Path? Can someone explain, why ...
I have wiped out all my old configurations and reconfigured everything.Now multicast is working.
First, I didn't issue
ip pim register-source Loopback0
command in R1.so it continuously got register message in
sh ip route
output . After configuring th...
Hi,
Do you think I should remove these configurations on Source host too?.Here I have given
rp address
command too.
Source#sh runBuilding configuration...hostname Source!!no ip routing!!!!!!ip multicast-routingno ip cefno ipv6 cef!multilink bundle-na...