David Ruess

Hello, Could you provide a diagram and configs of your devices? There is not enough Information to a...

Can you show the output of these commands? debug etherchannel alldebug lacp all Also try 2 things: 1...

Never create the port channel first. Delete the port channel and go into an interface and delete any...

Hello, Try deleting the port channel and the interface configs. (copy to clipboard) Configure like t...

As per my answer above you should be able to get it from the show version command. You may get multi...

Hello, Try “show version” It should be towards the bottom of the output with serial number. -David

Hello, What is the assigment directions say? Can you show the config for both devices? -David

Hello, Can you provide the ntp configurations you made on each device? Are IPs configured on each de...

Hello, EIGRP is still CISCO proprietary as in CISCO still owns it, however they have released a lot ...

Sorry I see it now. Is IPv6 enabled on the interface? Also you may need to use the match any and not...

Hello, I see where you made the IPv6 ACLs but didnt reference them in a class map. You will need to ...

Hello, What is the IP address and mask of the interface connected to the switch? It should be 10.0.0...

Hello, Try changing your subnet mask for interface vlan 211 to either 255.255.255.0 or 255.255.255.1...