Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can't communicate with anything connected on the inside interface.
See the attached command prompt ipconfig. I get an IP address and default gateway from the inside address pool of the ASA (100.100.100.240) but i can't communicate or ping anything ...
I can't communicate with anything connected on the inside interface.
See the attached command prompt ipconfig. I get an IP address and default gateway from the inside address pool of the ASA (100.100.100.240) but i can't communicate or ping anything ...
Setting up a Cisco ASA 5505 for a remote access VPN. I can connect to the device remotely and I get an IP address and subnet from the ASA but the default gateway always ends up displaying ":: (enter) 100.100.100.1" The 100.100.100.1 address is the c...
I am new to setting up an ASA 5505 and am getting a weird issue. I can connect remotely to the VPN and I am given an inside IP address from the address pool but my default gateway is always wrong and always has :: and then the default gateway. Theref...
Nothing seemed to change. Below is what part of my config looks like. I still can't get out from .241
ftp mode passiveobject network obj_any subnet 0.0.0.0 0.0.0.0object network NETWORK_OBJ_100.100.100.240_29 subnet 100.100.100.240 255.255.255.248obj...
with the command "packet-tracer input outside tcp 100.100.100.242 1025 100.100.100.33 80" i get the below response. .242 is an unoccupied ip from my inside pool list and 33 is another PC that i physically connected to VLAN 1
Result:input-interface: o...
The default gateway for the controls equipment on the 100.100.100.xxx network is either 100.100.100.1 or it's not filled out.
I'm not familiar with packet-tracer. When I try that command, it stops after "outside" and the only commands that i can giv...
I really don't need to access the inside interface, i just meant that i couldn't ping it. I need the address pool to be in the same subnet in order to talk to the various motor controls equipment on that network.
