Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,When I try to edit an AP found in Inventory of Catalyst Center, I get the following message: "Cannot perform selected action, reason: 1 device out of selected devices are either Meraki device or Unified AP or Wireless Sensor." As far as I ...
Hello Team,Wanted to check with you if you know what is the default polling interval for Catalyst Center in regards to WIFI Telemetry, and how can I change that interval?As far as I have seen, the only polling interval that I have found is for pollin...
Hello Team,If I want to stretch BDs, in the stretch template besides the VRF/BDs with L2 Stretch know enabled and EPGs, before doing that safe I have the following questions:1). Is there any traffic impact when importing into NDO, and I need to do it...
Hello Team,I have a question. If the only way to change L2 MTU on Nexus5672 is globally using policy maps (this is also represented in the following guide https://www.cisco.com/c/en/us/support/docs/switches/nexus-9000-series-switches/118994-config-ne...
Hello Team,I have a concern about the following statement taken from the below Cisco guide that will apply to ACI Multi Site setup:" The original infra TEP pools used for each fabric bring-up (10.1.0.0/16 and 10.2.0.0/16 in the example in Figure 1) d...
Hi @eduard.stoica ,Thanks for the provided feedback.Related to the following reply "Likewise, there is no impact in stretching the VRF and having some EPGs local in APIC", at the point of stretching I did that only for the VRF (if I do recall correct...
I think that I understand your answer and I agree with you. What started this discussion is the command show telemetry ietf subscription all detail from the WLC9800 which showed Periodic values that are lower and higher which kind of worried me.If I ...
I do not know what to say about reboot but increasing the vCPUs and memory for the controllers should help I guess, if the polling interval cannot be increased?
Thanks for the answer. The worry is that the polling interval is to short and my idea was to increase it somehow so that it lessens the CPU of either the APs or the controller.
