Hello Everyone . I am implementing cisco WSA with one of my customer.Customer has Palo Alto as firewall and catalyst 9400 as LAN core.The FW has PBR configured based on source address and pointing to different routers.Also integrating WSA with third ...
Hello ,
i have a small setup with customer where we need to advertise both the routes neigbor.
we have default routes injected from both the location (location1 and location 2)
when R3 receives it it has both the default route, but installs onl...
we would like to perform load balance in edge routers connected to same ISP.
the edge routers are running IBGP between them using IGP protocols as OSPF.
the Edge routers connected to ISP are running EBGP.
i am trying to follow the example i...
i don'tthink there should be any difference in running ibgp , any way R5 and R6 is considered as ISP in our topology , so we can run ibgp but the most important thing is that R5,R6 & R7 should routes of internal for reachability.since we already have...
Dear Gorge,
yes we can run ibgp but, already we have done bgp/ ospf redistribution in R5 and R6 so by default R7 should have the routes as received by ospf.
Dear Goerge,Even for 10.10.10.10 and 20.20.20.20 the traffic is not shift see the trace route results.Router#sho ip int briefInterface IP-Address OK? Method Status ProtocolFastEthernet0/0 10.1.13.1 YES NVRAM up upSerial0/0 unassigned YES NVRAM admini...
Dear Goerge,Even for 10.10.10.10 and 20.20.20.20 the traffic is not shift see the trace route results.Router#sho ip int briefInterface IP-Address OK? Method Status ProtocolFastEthernet0/0 10.1.13.1 ...