Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have BGP multi-path setup but only one router in AS65222 is receiving traffic for the prefix 192.0.2.254. Goal is to have traffic from cloud distributed between AS65222 routers to the anycast ip. Thoughts on what is going wrong here? Topology is: ...
Is the following possible? I'd like to have static DHCP leases configured on a Cisco 7200, if the router can't fulfill the client request (because no static lease exists for its MAC) then relay to an external DHCP server. Any thoughts?There is a feat...
I have a ubr7200 with MC28U and NPE-G1 running:Cisco IOS Software, 7200 Software (UBR7200-JK9SU2-M), Version 12.2(33)SCD7, RELEASE SOFTWARE (fc2)ubr7200-jk9su2-mz.122-33.SCD7.bin I cannot assign an IP to the cable x/x interface. IP address is not an ...
With the following setup, DHCP host routes are added until lease expiration, they then disappear and are not re-populated.6500 WS-SUP720-3B with MSFC3 (Redundant in sso mode)s72033_rp-PK9SV-M Version 12.2(18)SXD7bFlexWAN - WS-X6182-2PA with PA-A3-OC3...
Good to know its based on least significant bit. Unfortunately no change - 192.0.2.1# show routing hash 10.0.0.2 192.0.2.254
Load-share parameters used for software forwarding:
load-share mode: address source-destination port source-destination
Univ...
I'm running Nexus 3k, doesn't look like its supported. Also found this, no matter what source IP I use it has the same result: 192.0.2.1# show routing hash 10.0.0.2 192.0.2.254
Load-share parameters used for software forwarding:
load-share mode: add...
Testing was done with multiple source IP’s. In this diagram the router performing multipath is running NX-OS. I tried changing load-sharing options with no luck. Is NX-OS able to perform load sharing for bgp learned routes?
