Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm not sure if I'm overthinking this but I'm not sure where to make the ACL for the following purpose... We have a WiFi controller bridging VLANS directly into a Nexus switch, there has been SNMP traffic going to VLAN 5 from 50 but I only want VLANS...
The Nexus does not support multiple access-maps, I had tested it working with multiple access-maps on a 2960 but I'm not sure which of my notes was the correct one so won't put it in here.I had a ticket open with Cisco and Jason gave me a solution as...
I wasn't able to find an answer to this today, I used a test network with the configuration below but nothing is allowed through. When I try to use a sequence number for an access-map I get "ERROR: Mutltiple access-maps not supported". I was trying t...
