Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Here I have a C2960 switch, in this switch there is a computer connected to the port 1/0/1, and a router connected to port 1/0/24.show run on the switch shows:!ip routing!interface GigabitEthernet1/0/1switchport access vlan 10switchport mode ac...
Hello,Here is a C2960-XR, ip routing is enabled, two SVI are created and IP are given, two vlans are created and are appearing in the vlan database, but still cannot ping a machine in a vlan from a machine in an another vlan. whait is missing?Any id...
in my test lab I have replaced the dsl modem with a fortigate 30E firewall, but still the switch is not routing the traffic to the firewall? any advice how to make that work?
This is a test lab. in the production there is a Cisco ISR1100 sd-wan router, so will this work there?Btw the sd-wan switch side IP is a class A private range IP.
well I didn't turn it off but instead I had allowed ping in windows firewall in inbound icmp ecorequest 1pv4 so it was allowing ping in the same subnet but apparently its not allowing on different subnet. kind of strange behavior from windows firewal...
ok it worked. the issue was the windows firewall. disabling the firewall completely in both machines made the ping work. but the strange thing is when icmp is allowed on the windows firewall it was allowing ping only when both computers are in the sa...