Hello, I need assistance with a SG300 switch in a L2 mode. I am using a Synology router with a Synology access point (wired back haul) in a mesh network. When connecting to the AP on the primary network I have no issues. When I attempt to use th...
Randman, I changed the default VLAN to 1733. It did not work the way I wanted. The only thing that work was to connect directly to the router and I checked off "Allow guest to connect with each other." I have a wired house which helped. Did not n...
Thanks Randman, I am familiar with both links. The Cisco link was my go-by and it never worked. I think the 2600 cannot understand VLAN tags. I had my router and WP port as VLAN 1UP and VLAN 1733T. Guess network from the WP would not work, but pri...
Hi BB, I untagged both the router and AP port and changed the PVID to 1733. All clients loose internet connection (primary and guest network). Every attempt to change the PVID from the default VLAN 1 to 1733 on either port makes this happen. Once ...
Hi BB, Yes, its Internet-->Synology Router-->SG300-->Synology AP. I have all ports Trunked and Admit All. All ports are untagged under default VLAN 1. I have two ports tagged under VLAN 1733 (Router & AP). Membership shows all ports as 1UP. Two...