Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an SG300-20 here for testing (firmware: 1.1.2.0, boot version: 1.0.0.4, language version: 1.1.1.6 English). Everything seems to work on it, except, that if I choose Radius authentication by mac address only, then the switch does not honor t...
Hi Alexander and Jan,I am sorry, I did not check that. But if Jan needs help with this, then of course my offer is valid for him too... Best regards,Geza
Hi Alexander,Could you solve this problem, or you still have troubles with MAC based authentication and VLAN assignment? Because I have a working MAC-only based authentication here, I can send you the running configuration, and also the freeradius co...
Hi Alexander,I did quite some testing around with the SG300-20 I have here, which has the latest (1.1.2.0) firmware on it. And I have some problems with the reauthentication too. So my findings about your problem. There are two kinds of "reauthentica...
Hi Sharath,Thank you for the reply.I did a post in the "Small Business Switches" section (https://supportforums.cisco.com/thread/2128103), because it is not a problem with the wireless part (it was just easier for me to test it that way), but rather ...
Hi Alexander,Thank you for the prompt answer.I am not a newbie in network management, but I am a newbie in Cisco management . May be it is just the terminology problem on my side. From my point of view the following happens:1. The SG300 asks the rad...
