Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
As i can see in my forwarding table both default and ospf routes are there. is it normal behavior??
But no static or default routes are used in this switch. physical connection is as below.
source----------Switch_1-------Switch_2---------destinat...
Hi,
Our physical connection is as below. 3 GE links are connected from L3 Switch-A to L3 Switch-B. OSPF is running B/W SW-A and SW-B.
SW-A ---------3GE links-------SW-B
Maximum paths 3 is configured to utilize all 3 links(As LACP is not supported he...
Hi,
I have one L3 Switch & one router and i'm pinging to loopback IP address of both switch and router and result is as shown below
PC-------L3 switch-------router
PC to L3 SWITCH ping dalay min/avg/max= 8/12/74 ms.PC to ROUTER ping delay min/avg/...
SWITCH-1#show ip ospf database process 220
OSPF Router with ID (10.46.255.54) (Process ID 220)
Router Link States (Area 0.0.0.0)
Link State ID ADV Router Age Seq# Checksum Link count10.2.96.125 10.2.96.125 1239 0x800032d2 0xbee4 610.2.96.126 10.2.96....
Yes pinging to an loopback interface or VLAN interface on a switch always giving varying results. But CPU utilization is always <10% .
We are using ZTE 8900E series switch and M6000-S series router. but the result is same...
In ZTE Switch there is n...
