About a-michi

a-michi · 01-20-2017

I'm using "AIR-LAP-1042N-T-K9" in our office with firmware 8.0.120.0. On my Surface Pro 4 (MARVELL AVASTAR 88W8897 support - ac/a/b/g/n) But why the most of time my Surface Pro 4 always connect 2.4Ghz signal not 5Ghz? because my Surface Pro 4 doesn'...

a-michi · 01-25-2017

Yes this statement is base on the Surface Pro 4. -50dBm is the number when surface start to switch to stronger signal.

a-michi · 01-25-2017

I would like to verify this statement. Because we are using 1042N, 1600, 1700 cisco router, our partner told me that although 2.4ghz support 802.11n but they are not recommend to open. Is this true? The 802.11n protocol, which was ratified as an ame...

a-michi · 01-23-2017

I got the feedback from surface team. Depending on wireless noise/signal quality that number is around -50dbm. With Band set to Auto: If “Router” is operating on 2.4 and 5ghz, and the 2.4ghz channel is much better than -50db but the 5ghz channel is w...

a-michi · 01-23-2017

Hi Scott, It's good to hear this. So after the driver update than we can configure the wireless setting? like 5Ghz prefer or roaming sensitive?

a-michi · 01-22-2017

Hello Leo, Surface Pro 4 use MARVELL AVASTAR 88W8897 chip Only have 3 setting.

Member Since	‎01-20-2017 10:31 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	7

User Statistics

User Activity

1042N and Surface Pro 4 Wireless Settiing

Yes this statement is base on

I would like to verify this

I got the feedback from

Hi Scott,

Hello Leo,