Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiCisco recommended antenna mounting height (indoor) is between 10 and 15 feet (max 20). Could you please share your thoughts on these:- you mount APs (let's say 30 APs) in the warehouse: a) in the scenario A all APs are mounted on the same...
HiWhat is the best way of doing a site survey when APs are managed by a controller? What I mean is that the AP can be set to different power level when there is a low and high number of clients - in such case a survey may not deliver correct data (wh...
Hi AllLet's say we have two types of switches:1. WS-C2960-24TC-L (Uplinks - 2 Dual Purpose) 24Gb ports + 2 dual purpose uplinks2. WS-C2960-24-S (Uplinks - None) 24Gb portsEdit: I've given a wrong models.Questions:1. Is there any major difference betw...
HiI've been wandering recently if there is any advantage of connecting 2 x 2960 with the fiber rather than Cat 6 short patch cable (let's say 15cm - the switches are adjacent two each other so the patch cable will be very short).Speed is the same, no...
HiI have a mixture of switches in our network - 3750s (wireless controller), 2950s, 2960s, 3560s. We purchased the monitoring software but I have to upload the MIBs before I will be able to get any data from the devices. For a start, I'd like to mon...
Scott,What do you think about passive vs active survey? Which do you carry out more often (especially in the case of a post survey)?In the case of active survey what roaming aggressiveness you use? I would trust the WLC in setting the correct channel...
HiHow can I check the power level of the client? Shall I check a vendor's spec for the wireless card?As I mentioned in the reply to Scott - I'd like to get the picture of my WLAN as-is and maybe after that start making changes.Thanks.
Thanks for the reply. I do not have much experience with WLANs so I do appreciate your help.Have you done a site survey prior to the install? - I was told the survey was done. I need to contact the company and get the information.If you are doing a p...
