Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a single unrestricted PIX 515e running with 3 interfaces in use. Each interface is configured 100 full duplex into a cisco 3550 switch again with ports set at 100 full.Traffic throughput is around 800kbps on each interface which with the avai...
Hi, I hope somebody can help me out. I am using a H323 gateway (Cisco 2811) connected to an ISDN 30. I have full outbound connectivity from the Cisco phone to the PSTN. Ring tone etc is present.When I call inbound to a specific IPT phone from the ...
Hi, we are using call manager version 4 and a 2811 gateway runing h323. The problem we have is that we are able to dial between handsets internally but as soon as we try to dial outbound or receive inbound calls they fail. I am trying to follow the ...
We currently have a call manager running version 4 and a 2811 gateway connected to an ISDN 30. Having problems working out how we get an engaged tone enabled once all the circuits are utilisedI would also like to know if there is a way of reserving ...
I have a 2811 router with isdn connectivity. DDI numbers allocated are similar to 455xxx where xxx is 100 to 299I need the call manager to allow these calls to go to device numbers in the format of 8xxx where the xxx relates to the ddi number.Is the...
thanks for the feedback. Greatly appreciated. I still do not appear to have this working. More specfic detailsisdn presents inbound call as 874007. I have a directory number of 4007 I have entered a translation pattern of 874xxx along with a mas...
Perhaps I could add a little more if that is ok. I have checked via debug isdn that the requested number is presented on the gateway. Is there a way of checking that this is passed to the call manager?RegardsSimon
