About rangerdon

rangerdon · 09-17-2020

I have a catalyst 9300 switch that I have attempted to configure identically to 11 other 9300's in an effort to perform a firmware update. On the previous 11 switches I could scp through the configured IP to obtain the firmware bin file and save it ...

rangerdon · 09-17-2020

No... nothing fancy like that. These switches are just used to teach basic ios commands to students, allow them to configure a vlan, setup a small dhcp server, capture and analyze network traffic, etc. Each switch is connected to one linux pc by a ...

rangerdon · 09-17-2020

First, information from the switch: co2061-9300-07#ping 192.168.75.14 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.75.14, timeout is 2 seconds: ..... Success rate is 0 percent (0/5) co2061-9300-07#show arp Protocol Addres...

rangerdon · 09-17-2020

I enabled it and it didn't seem to make a difference.

rangerdon · 09-17-2020

The management port allows connectivity to the switch from one machine. Once inside the switch I cannot ping through the port with the assigned IP. I am following the same procedure I used to configure the previous switches and while it worked on 1...

rangerdon · 09-17-2020

I Was attempting to indicate that the "server" was on the same ip subnet as the port that is not allowing the traffic through. The switch port is Gi1/0/11. I've included the running config below the port specific information. Here is more informat...

Member Since	‎09-17-2020 06:41 AM
Date Last Visited	‎09-20-2020 09:27 AM
Posts	6

User Statistics

User Activity

Cisco 9300 cannot ping or ssh after setting an IP on port

Re: Cisco 9300 cannot ping or ssh after setting an IP on port

Re: Cisco 9300 cannot ping or ssh after setting an IP on port

Re: Cisco 9300 cannot ping or ssh after setting an IP on port

Re: Cisco 9300 cannot ping or ssh after setting an IP on port

Re: Cisco 9300 cannot ping or ssh after setting an IP on port