Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We faced a problem while trying to configure l2 mpls vpn on a GigE interface of a 7206 VXR router. (IOS-124(4)XD2 NPE-G2). The problem is that when applying the command "mpls l2transport route x.x.x.x vcid" to the specific subinterface the router ...
Hi everyone,I'm trying to establish a GRE IPsec tunnel between two cisco routers ( 2620XM and a 836).I've created a the tunnel interfaces on both routers as follows,2620XMinterface Tunnel0 ip address 10.1.5.2 255.255.255.252 tunnel source x.x.x.x tun...
Hi,As i wrote in a previous post the issue solved when i applyied the crypto map to the external intfs of the routers.Before i was trying to establish the IPsec/GRE tunnel using the ips of internal interfaces. Now everything works fine!But still i wo...
Hi,Well you can find info about this in the following link.http://www.cisco.com/en/US/customer/products/sw/iosswrel/ps5207/products_field_notice09186a0080697964.shtml It mentions that applying crypto map in both tunnel and physical interface isn't ne...
Hello,I've changed the peer ip address from the two routers and it worked. To be more specific in previous configuration i used the ips of the internal interfaces (FastEthernet 0/0.2 and Ethernet0 in 2620XM and 836 accordingly) as peer ips and tunnel...
Hello,Here is the output.2620XM#sh crypto isakmp sa dst src state conn-id slot2620XM#sh crypto ipsec sa interface: FastEthernet0/0.2 Crypto map tag: myvpn, local addr. x.x.x.x protected vrf: local ident (add...
