Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have 16 devices that are configured with same IP that I can not change. Now I want to interface a PC terminal via a CISCO network switch SG350-28SFP. A snapshot is also attached for reference. Can some one please guide me the procedure to this.
Hi, I have a SG350-28SFP network switch. Can I use its 24 ports with an SFP that has a maximum data rate of 100Base? Because my other networking equipment supports a maximum of 100Base connection, so Cisco switch is not responding with a 1G/10G SFP m...
Hi, I know design is wrong. But this is a practical challenge we have to overcome. These 16 devices are remote and locked for editing. So IP change is out of question. We have to find a way to interface all of these devices via a router/gateway as sh...
Hi,Here is the solution for such problem. As Cisco switch is manageable, I logged in to its configuration web portal and changed its port data transmission speed from 1000Base to 100Base. Now same switch with same SFPs is communicating to all equipme...
