Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiIt's been awhile ....If I copy the running-config to disk0:/running-config-112706.cfgto restore that configall I have to do is copy disk0:/running-config-112706.cfg running-config ??no write mem ?Thanks
HiI need to set the fragmentation for a Multilink interface for 350 Bytes that has 4 T1sIs that done on the Serial T1 interface or the PPP Multilink Interface ?what would be the commands, currently PPP Multilink shows fragmentation 1496 frag sizeThan...
Hello,I have a 7204 Cisco Router with T1 inteface and the traffic is supposed toto outputing to the Fastethernet portI was trying to monitor the trafficI have looked at the sh intsh int statsh int accountingand I see a different in the in the traffic...
HiI have two T1s in a Multilink 1 groupand having issues with the bundle name not always being the same and thus causing only one T1 to be able to join the bundledebugging -------------------------1w5d: Se1/0:0 MLP: Link not added to bundle1w5d: Se1/...
HiI was trying to tftp an IOS image to the flash card on the 7204 VXR and the sessions froze and now I cannot remove the image on the disk0:delete disk0:/c7200-is-mz.123-11.T2.binDelete filename [c7200-is-mz.123-11.T2.bin]?Delete disk0:/c7200-is-mz.1...
Hi Satish,I am running IOS 12.3(11)T2 on Cisco 7204VXRand do not have the commandppp multilink fragment size ## on either the Multilink or Serial interfacesonly can set the ppp multilink fragment delay disable maxium - specify # of fragments per tra...
Hi PareshHow would I calculate the delay to handle only 350 bytes on a Multilink bundle with just one T1 in the bundleI see the example on the Cisco web siteppp multilink fragment delay 20not sure how to figure out the delayThanksFrank
I think that is how I have it setupglobal command - ip cefhow is the bundle name assigned, as the T1 join the bundleby the source router ?or the far end router ?my source router======================================interface Multilink1 ip address 172...
Hi Ilya,I removed the ppp multilink endpoint commandsone thing I notice that I can ping the remote IP on the Multilink1 say 172.1.1.106but cannot ping the router side 172.1.1.105?Thanks
