Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I migrated from 6500 hybrid (IOS+CatOS) to IOS-only. After that, the policy-map applied in some interfaces only work in one Catalyst. For example, if a put the interface vlan X active in one cat with the bandwidth limited to 3Mb, everything is ok. Bu...
My two 6500 run in redundancy, with vlans balanced between them. One cat has the following cpu load:RJ6509_1#sh proc cpuCPU utilization for five seconds: 36%/32%; one minute: 47%; five minutes: 42% PID Runtime(ms) Invoked uSecs 5Sec 1Min ...
Hi all;I have two 6500 running as redundancy. They run HSRP and there are several vlans. I upgraded them with SUP2 recently and everything seems to be normal, but some things are a little bit weird.When I issue "sh ip cache flow" on both, I see a lot...
Hi all;I have two 6509 running with sup1A using IOS and CatOS. I'm replacing them for SUP2 and I'd like to move to unified IOS.Is there any reason to continue with CatOS ?? Which solution is the best ??The two Cat's are running in redundancy. If I is...
