Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear CommunityAfter added vlan 634 to CoreSwitch1 (CatOS6509), the ethernet channel ports on CoreSwitch1 were disabled due to errors (pls see the log below).CoreSwitch1>2007 Aug 08 10:29:31 AEST +10:00 %SPANTREE-2-CHNMISCFG: STP loop - channel 5/1-2 ...
Dear CommunityPls see the "show ip bgp". For me the path No.2 and No.4 have the same conditions, why path No.4 is the best. What is the mechanism to choose it?R1>sh ip bgp 10.20.0.0/19BGP routing table entry for 10.20.0.0/19, version 18108Paths: (4 a...
Dear CommunityI want to run OSPF Version 3 on my Cisco 2620 router, But I could locate the IOS from Cisco Web Site. Any body can guide me through?Thanks in advance....Kelvin Cheung
Sorry the last statement shall be:I telneted into the switch for management purpose, the session was timed out if there was no acitivity. Please help why it is not working?????
Hi SunderThanks for your help....Sorry to trouble you again. Pls see the 'sh version" and "sh run full". I did put the command 'spanning-tree etherchannel guard misconfig' in, however, I could see it in the config. Do you know why?R4#sh verCisco Inte...
Dear SundarPls see the show version below, I do'nt think I have the 'spanning-tree etherchannel guard misconfig' in CATOS version,Thank a lots......CoreSwitch2> (enable) sh verWS-C6509 Software, Version NmpSW: 8.3(5)Copyright (c) 1995-2004 by Cisco...
Thank you for your help, Pls see the config below:CoreSwitch1> (enable)#port channelset port channel 5/1-2 5#channelprotocolset channelprotocol pagp 5#channelprotocolset channelprotocol pagp 5! #port channelset port channel 5/1-2 5set port chan...
