Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1811/k9 Router and i want to implement security by MAC address on the 8 ports that are used as a siwtch.How can i accomplish this?Thanks for helping
Is it possible to configure an ACL that will allow internet traffic to come toward the PC's that access the internet only if there has been a request from these PC's (the network inside)? If yes, how?What I mean is how can I use the ACL's to minimize...
HelloI'm attempting a dial up backup from a 1811 cisco router. From the debug it seems that the router places the call and it says on the interface that it was a successful call, but i get nothing on the other router that has to be dialed.On the debu...
GreetingsI need to create a dial Back up connection that comes from a Cisco 1811 running c181x-adventerprisek9-m 12.4 (6)T7.The router has 1 interface connected that communicates with the Home Branch through a service provider. The router has a VPN c...
HelloI have a Router 1811 and a PIX 515E. Both are connected with a VPN tunnel. Everything works OK but in times of inactivity the PIX deletes the connection and after that the remote site (Router) cannot start the VPN. the PIX gives this message7100...
RickI did not find the debug isdn q931 on the available list of commands.My router is a cisco 1811 and has a V92 port.Here you have attacked the router config.Thanks again for your help.
Well since it was asked this is a solution I'm trying to solve this problem and that is working so far.To the router i set an isakmp and ipsec lifetime of 3600 seconds. this way as soon as the time passes the router and the pix are forced to exchange...
OKmore to this problemIt seems that the problem originates at the router.If i give the command : clear crypto saafter that the VPN can start normaly from the router to the PIX.Please any idea how can i fix this without giving a command manualy?regard...
"710003: ESP access denied by ACL from "router IP"/12304 to PIXINTERF:IP/24081. " Is what the PIX Debug gives when i start a ping from the router internal network toward the PIX INternal network.I'll check on the reflexive lists and let you know when...
