About erick.friedman

erick.friedman · 08-01-2006

hi there, in a nutshell I have implemented vlans on a cisco switch network. the core 3550 switch can see all vlans, vlans devices can see each other beautifully. The problem is the original 2600 router with an IP of 10.147.8.1 can only be seen by dev...

erick.friedman · 08-01-2006

yeah i think its strange too. SInce there are no ACL's in place should I put a permit all ACL in there just to make sure?I can get the laptop in that vlan to act the same way as the router if I change the gateway on the laptop to something other then...

erick.friedman · 08-01-2006

okI have a core switch 3550 with ip of 10.147.30.1I have 3 4948 IP's 10.147.30.2-10.147.30.5I have a 2960G with IP of 10.147.30.6All of these switches connect back to the 3550 via fiber ports that are set to trunk at the same encapsualtion. I have vl...

erick.friedman · 08-01-2006

the router is connected to a port on a 2950G switch I assume this is a lyer 3 switch?,which is configured for access to Vlan10 10.147.8.2The route I have configured on the 3550 is as followsip route 0.0.0.0 0.0.0.0 10.147.8.1 (2600 router)thanks for ...

Member Since	‎08-01-2006 05:13 AM
Date Last Visited	‎08-18-2017 03:53 AM
Posts	4

User Statistics

User Activity

router on vlan problem

Re: router on vlan problem

Re: router on vlan problem

Re: router on vlan problem