Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have Cisco Firepower Management Center 4000 hardware appliances.They are running the current Cisco recommended version of Firepower software i.e. 6.4.0.9These FMC 4000 hardware appliances are based on Cisco UCS C220 M3 rack servers, and each conta...
On FMC 4000 (running 6.4.0.9 software) I am unable to delete SNMP alerts i.e. on the FMC when I navigate to Policies > Actions > Alerts when I attempt to delete an SNMP alert, the message shown in attached screenshot appears:i.e. "This Alert Configur...
We are deploying Firepower Management Center 4000 appliances (Cisco Part Number: FS4000-K9) As part of our system deployment we are looking to install our own CA signed PKI certificates on our network equipment. Our IT security requirements are that ...
Hi Cisco Community We are working on a solution involving the deployment of Firepower 7125 hardware sensors (i.e. Cisco part number FP7125-K9) managed by Firepower Management Center 4000 appliances (i.e. Cisco part number FS4000-K9) and plan to deplo...
The "Cisco Identity Services Engine (ISE) Network Component Compatibility" document (Release 2.4) here does not have any Nexus devices listed.
Can anyone on the community confirm if:
Nexus switches are compatible / incompatible with ISE running v...
For the record, have proven this work in our lab, with an FMC 4000 appliance (rather than an FMC 2000) under the following setup:
- Physical NIC “1” (logical interface “eth0”) – ORIGINAL interface connected to subnet/VLAN X
- Physical NIC “M” (CIMC...
Thanks again Martin
I have been taking another look at bug CSCuu97541 ("Turn off older SSL/TLS versions and ciphers")
The description of the bug reads as below:
"This is a modification on the Cisco FireSIGHT System Software to adopt new secure co...
Thanks Martin for this additional info.
We are considering upgrading our FMC 2000 appliances from 6.1.0.3 to 6.2.3.2
Our FMC 2000 appliances currently manage Firepower SFR software modules in ASA 5500-X series where the Firepower SFR software modules...
Thanks Marvin
I have just checked bug CSCuu97541 and the fixed released are listed as:
6.2.2
6.2.0.4
6.1.0.5
5.4.1.9
5.4.0.10
with 6.1.0 listed as an affected release.
We are running 6.1.0.3 on our FMC 2000, so it looks to me like we would need to up...
